PHILIPS MASTER TL-D Reflex ECO

×

Fitting

Light color

Wattage

Length

More

Philips Starter S2

Starter S2

High quality glow switch starters for igniting fluorescent lamps with ballast.

€0,99 / stuk Excl. tax

(€1,20 Incl. tax)
more info
Philips Starter S10

Starter S10

High quality glow switch starters for igniting fluorescent lamps with ballast.

€0,99 / stuk Excl. tax

(€1,20 Incl. tax)
more info
Philips Starter SiS10 30-65W

Starter SiS10 30-65W

Starter for fluorescent lamps. System is immediately ready for use again by simply pressing the red button after an interruption.

€4,95 / stuk Excl. tax

(€5,99 Incl. tax)
more info
Philips MASTER TL-D Reflex ECO 36W/830 (120cm)

MASTER TL-D Reflex ECO 36W/830 (120cm)

Energy label A. TL-D Reflex uses the internal reflector to direct the light where it is needed. Because the internal reflector directs all the light downwards, there is no loss of light from dirt accumulating at the top. Length 120cm. Light color 3000K

€10,95 / stuk Excl. tax

(€13,25 Incl. tax)
more info
Excl. tax

Daylight G13 lamp base lamp base, lamp shape T8


PHILIPS MASTER TL-D Reflex This means that the fluorescent lamp needs to be cleaned less often and brings 40% more light down .

The life of the PHILIPS MASTER TL-D Reflex is 1.5x longer than the standard color TL-D and the light output is 30% higher with the same energy. Also during this time, the light intensity remains higher than the standard fluorescent lamp. The Philips TL-D has a 50% failure rate at 20,000 hours on HF ballasts, (12,000 hours with standard ballast. This PHILIPS TL-D lamp with G13 lamp base is dimmable with a suitable ballast. Lamp shape T8

Available in the light colours:
830 (warm white), 840 (bright white)

Defective PHILIPS MASTER TL-D Reflex lamp is easy to recognize by the black breakdown in the lamp at the end on 1 side! If this is the case on both sides, the ballast is often broken. Usually the lamp slowly starts to give less light from 10,000 to 12,000 hours. It may be wise to replace it in good time due to the risk of the electronic ballast becoming defective. Due to wear of the lamp, it will consume more power, which will load the VSA.

Lamp base information PHILIPS MASTER TL-D Reflex

T8 lamp with G13 lamp base sketch T8 lamp with G13 lamp base lamp holder G13
lamp base G13 T8 lamp with G13 lamp base lamp holder G13  

You can change the PHILIPS MASTER TL-D Reflex with 2 pins on each side by turning it out of the fitting with a gentle rotation 90 degrees to the left or right. De-energizing the fixture is necessary to allow the lamp to burn, but it is also safer.

Environmental aspects of the PHILIPS MASTER TL-D Reflex lamp.

All TL-D lamps fall under Energy efficiency label (EEL) A. The mercury content of the PHILIPS MASTER TL-D Reflex lamps is only 2 mg. Below the various TLD lamps and their energy label.

Application PHILIPS MASTER TL-D Reflex

-Suitable for various "TL"-D fixtures. This lamp is often used in schools, offices, shops, factories, etc.

Benefits PHILIPS MASTER TL-D Reflex

Covered with special fluorescent layer for better color rendering (Ra>80)
- 1.5 times longer lifespan than the standard color TL-D lamps
- Higher efficiency with HF control gear
- 30% more light for the same amount of energy than standard TLD lamps
- Creates a color climate ranging from warm white to cool daylight

Please accept cookies to help us improve this website Is this OK? Yes No More on cookies »